Skip to main content

Power OFF the Copier / Printer and Disconnect the Communication Cables. Wait 30 Seconds, Then Power ON and Reconnect the Cables

Article Id: x_c2424_en-O5733 | Published: 05/02/2016

Product support for
  • Phaser 8510 MFP
  • Phaser™ 8560MFP
  • Phaser™ 8860MFP
  1. Access the power switch by opening the Interface Cover on the right side of the machine.
  2. interface cover

  3. Power OFF the machine.

    power switch


  4. Disconnect any interface cable(s) connected to the machine (USB and / or Ethernet cable).

    NOTE: Wait approximately 30 seconds before powering ON.

  5. Power ON the machine with the interface cable(s) disconnected.
  6. If the machine powers ON and boots up as normal, continue with the next step.  If the machine begins to continuously power Off and On again, contact support. 
  7. Reconnect the interface cable(s).  If the machine begins to continuously power Off and On again, contact support.

Did this help?