Skip to main content

Load Paper Tray 2

Article Id: x_7760_en-O1520 | Published: 02/11/2016

Product support for
  • Phaser™ 7760

CAUTION: It is important that the setting on the Control Panel matches the media type loaded in the paper tray. Failing to use the correct paper type setting can result in jamming, print quality degradation, and Fuser damage.

NOTE: See the Related Content for additional information about paper specifications.

To load Paper Tray 2:

  1. Open the paper tray.

    Open Tray 2

    Open Tray 3

  2. Fan the paper to release sheets that are stuck together.

    Fan the Paper

  3. Adjust the paper width and length guides to match the size of the paper.

    Adjust Tray Guides

  4. Insert a stack of paper into the tray. Do not load paper above the MAX fill line or paper jams may occur.

    Do Not Load Past Max Fill Line

    NOTE: Refer to the table below for supported paper sizes and paper loading orientation.

  5. Close Paper Tray 2. The Display Screen will display a prompt to confirm or change the selected paper type and size.
  6. If the selected type and size are correct, press the [OK] button. If not, change the type and / or size:
    1. Press the [Down] arrow button until 'Change Setup' is selected, and then press the [OK] button.
    2. Press the [Up] or [Down] arrow button until the correct paper type is selected, and then press the [OK] button.
    3. Press the [Up] or [Down] arrow button until the correct paper size is selected, and then press the [OK] button.
Supported Paper Sizes and Orientation
NameMetricImperialOrientation*
Statement140 x 216 mm5.5 x 8.5 in.SEF
Letter216 x 279 mm8.5 x 11 in.LEF
Folio216 x 330 mm8.5 x 13 in.SEF
Legal216 x 356 mm8.5 x 14 in.SEF
Tabloid / Ledger279 x 432 mm11 x 17 in.SEF
A3297 x 420 mm11.7 x 16.5 in.SEF
A4210 x 297 mm8.3 x 11.7 in.LEF
A5148 x 210 mm5.8 x 8.3 in.SEF
B5176 x 250 mm6.9 x 9.8 in.LEF
B4250 x 353 mm9.84 x 13.9 in.SEF

* LEF = Long-Edge Feed / SEF = Short-Edge Feed

Guidelines for Loading Paper Long-Edge Feed (LEF)

Long Edge Feed Orientation

  • Place the side to be printed face-up.
  • Pre-punched holes should be on your right as you face the printer, if printed single-sided. For two-sided prints, load pre-punched holes on the left side of the tray.
  • Letterhead should be at the front of the tray.

Guidelines for Loading Paper Short-Edge Feed (SEF)

Short Edge Feed Orientation

  • Place the side to be printed face-up.
  • Pre-punched holes should be at the back of the tray.
  • Letterhead should enter the printer last.

Related content

Did this help?