Skip to main content Click to view our Accessibility Statement or contact us with accessibility-related questions.

Install or Remove the Optional Wireless Network Adapter

Product support for: Phaser 6510

Article Id: x_6510_en-O2750 | Published: 04/02/2018

To Install the Optional Wireless Network Adapter

  1. Turn off the printer.

    Power the printer off

  2. To remove the Wireless Network Adapter Port Cover, press down the latch and pull it away from the printer.

    Remove the Wireless Adapter Port Cover

  3. Remove the packaging from the Wireless Network Adapter.
  4. To install the Wireless Network Adapter, follow the procedure defined on the instruction sheet provided with the Wireless Network Adapter.

    Install the Wireless Network Adapter following the instruction sheet provided with the adapter

    CAUTION: Pulling on the adapter can damage it. Once installed, remove it only as needed using the instructions below.

  5. Turn on the printer.

To Remove the Optional Wireless Network Adapter

CAUTION: Once installed, remove the Wireless Network Adapter only as needed.

  1. Power off the printer.

    Power the printer off

  2. To unlatch the left-side cover, slide the handle away from the printer, then swing the handle toward the rear of the printer.

    Unlatch the left side cover

    Unlatch the left side cover

  3. To remove the cover, slide it toward the back, then away from the printer.

    Remove the left side cover

  4. Reach into the chassis and push the release lever toward the front of the printer. Hold the release lever in this position and gently pull the Wireless Network Adapter away from the printer.

    Hold the release lever in this position and gently pull the Wireless Network Adapter away from the printer.

    CAUTION: Do not use force to pull on the Wireless Network Adapter. If the latch is released properly, the adapter pulls out easily. Pulling on a secured adapter can damage it.

  5. To reinstall the Wireless Network Adapter Port Cover, insert the bottom tab into the small slot. Gently press the port cover against the back of the printer until it latches into place.

    Reinstall the wireless adapter port cover

  6. Place the left-side cover into place, then slide it toward the front of the printer.

    Reinstall the left side cover

  7. To latch the cover, swing the handle toward the front of the printer, then push the handle in until it clicks into the locked position.

    Lock the left side cover into place

  8. Connect the printer to your computer with a USB cable or to a network using an Ethernet cable.
  9. Power on the printer.

Did this help?