Specify Output Settings at the Control Panel
- Product support for
- AltaLink C8130 / C8135 / C8145 / C8155 / C8170 Color Multifunction Printer
- Article ID
- KB0032113
- Published
- 2021-11-01
At the control panel touch screen, touch Device, then touch Tools.
Touch Device Settings.
Touch Output.
To prioritize copy and print jobs, select Contention Management. Select an option, then touch OK.
Priority: This option specifies the relative priority of the copy or print jobs. The lower the number, the higher the priority.
First In/First Out: This option schedules jobs to print, based on their entry into the Job Queue.
To specify how the device handles a print job that requires staples when the stapler is empty, select Out of Staples Options. Select an option, then touch OK.
To specify the default output location for jobs that do not have finishing options, select Output Location. Select an option, then touch OK.
To specify where the device applies staples to a print job, select Staple Productivity Mode, select an option, then touch OK.
To specify whether jobs are offset in the output tray, touch Offset. As needed, select or clear the check boxes for Center Tray Offset, Offsetting of Sets Within Jobs, and Conditional Finisher Offset. Touch OK.
Note: Not all options listed are supported on all devices. Some options apply only to a specific device model, configuration, operating system, or driver type. Some options are available only if a finisher is installed.