Replace the Second (2nd) Bias Transfer Roller

When the second bias transfer roller needs to be replaced, a message appears on the control panel.

1. Remove paper from the left tray, then fold up the tray.
   
   
   
   

2. To open Door A, lift the release lever, then open Door A.
   
   
   
   

   WARNING: The area around the fuser can be hot. To avoid injury, use caution.
   
   

   CAUTION: Do not touch the transfer belt. Touching the belt can reduce image quality or damage the transfer belt. Do not touch the transfer roller. Touching the roller can reduce image quality.

   
   
   
   
   

3. Remove the new transfer roller from the packaging. Retain the packaging.

4. To release the used transfer roller from the printer, pinch the orange levers at each end of the transfer roller, as shown.
   
   
   
   

5. Lift the used transfer roller out of the printer.
   
   

   Note: Do not touch any toner that adheres to the transfer roller.

   
   
   
   
   

6. Place the used transfer roller in the plastic bag.
   
   
   
   

7. Place the new transfer roller in the printer as shown. Press down until the transfer roller clicks into place.
   
   
   
   

8. Remove the protective cover from the transfer roller, then close Door A.

9. Reset the supply life counter for the Second (2nd) Bias Transfer Roller.  For additional information, click on Reset the Supply Life Counters.
   
   IMPORTANT:  Do not skip this step.  The supply life counter for this item must be reset in order for the device to function properly.