Skip to main content

Configure or Modify the Automatic (DHCP) IP Address on the Printer

Article Id: x_7800_en-O1435 | Published: 11/10/2016

Product support for
  • Phaser® 7800

The printer automatically acquires a network address from a DHCP server by default.

Configuring TCP/IP Settings at the Control Panel

Configuring the IPv4 Network Address for DHCP:

  1. Select [Printer] on the Touch Screen.

    Select Printer

  2. Select the [Tools] tab, and then select [Setup].
  3. Select [Network & USB].
  4. Select [Ethernet].
  5. Select [TCP/IP (v4)].
  6. Select [On:DHCP].
  7. Select [OK].

Configuring the IPv6 Network Address for DHCP:

  1. Select [Printer] on the Touch Screen.

    Select Printer

  2. Select the [Tools] tab, and then select [Setup].
  3. Select [Network & USB].
  4. Select [Ethernet].
  5. Select [TCP/IP (v6)].
  6. Select [On:DHCP].
  7. Select [OK].
  8. Select [DHCPv6].
  9. Select [Enable DHCPv6].
  10. Under Mode, select one of the following:
    • Router
    • Stateful
    • Stateless
  11. Select [Apply Now].
  12. Select [OK].

Did this help?