Skip to main content

Manually Configure or Modify a Static (Permanent) IP Address on the Printer

Article Id: x_7800_en-O1432 | Published: 11/10/2016

Product support for
  • Phaser® 7800

Internet Protocol (IP) is a protocol within the Internet Protocol Suite that manages the transmission of messages from computer to computer.

Configuring TCP/IP Settings at the Control Panel

Configuring the IPv4 Network Address Manually:

  1. Select [Printer] on the Touch Screen.

    Select Printer

  2. Select the [Tools] tab, and then select [Setup].
  3. Select [Network & USB].
  4. Select [Ethernet].
  5. Select [TCP/IP (v4)].
  6. Select [On:Static IP].
  7. Select [IP Address], enter the address using the keypad, and then select [OK].
  8. Select [Network Mask], enter the network mask using the keypad, and then select [OK].
  9. Select [Gateway Address], enter the address using the keypad and then select [OK].

Configuring the IPv6 Network Address Manually:

  1. Select [Printer] on the Touch Screen.

    Select Printer

  2. Select the [Tools] tab, and then select [Setup].
  3. Select [Network & USB].
  4. Select [Ethernet].
  5. Select [TCP/IP (v6)].
  6. Select [Manual].
  7. Select the [Enable Manual IPv6] check box.
  8. If necessary, select [Prefix Length], enter a new length in the field provided using the keypad, and then select the [OK] button.
  9. Enter the address using the keypad, and then select [OK].

Did this help?